Duracool 1
PRODUCT DESCRIPTION: DURACOOL I is a white mastic coating, made with superior elastomeric acrylic polymers. The product contains strong rust inhibitors, which makes it very suitable for application on metal roofs with varying degrees of rust.
RECOMMENDED USES: Primarily designed for uses on metal surfaces.
PRODUCT FEATURES: Water based coating makes to easy to use, easy clean-up, non-toxic, VOC compliant, non-flammable.
Excellent adhesion to various metal substrates.
Highly flexible, even at low temperatures.
Will not crack, peel or flake over the life of the product.
Contains a strong mildewcide / fungicide.
Contains strong rust inhibitive pigments.
Reflects 90% of the heat and UV rays from the sun.
Excellent reflective properties reduce cooling costs.
SURFACE PREPARATION: All surfaces to be coated must be clean, dry and free of oil, grease, or dirt. High-pressure water washing with DURACOOL ROOF WASH is suggested. Previously present coating must be checked for good adhesion. Any loosely adhering coating must be removed and bare surface must be prepared and cleaned and checked for compatibility, before coating.
APPLICATION PROCEDURE: DURACOOL I is ready to use, thinning is not required or recommended.
Brush: A good quality synthetic or nylon bristle brush
Roller: Long nap roller is recommended
Spray: Airless spray equipment, spray tip #631, 2 gpm capacity
LIFE EXPECTANCY: 12 - 15 YEARS
Technical Data:
- Color: White and other colors available on request (ASTM D-562)
- Viscosity: 95-105 KU, 77°F
- Specific Gravity: 1.44
- pH: 8.6 / 0.2
- Solids by weight: 67 / 2% (ASTM D-1533)
- Flash Point: None to boiling
- Hardness, Shore A: 55-65 (ASTM D-412)
- Tensile Strength at break: 250 psi at 70° F, 440 psi at 0°F (ASTM E-412)
- Tensile Elongation at break: 550% at 75°F, 350% at 0°F (ASTM D-412)
- Permeability: 5 perms / inch. 20 mils thick. (ASTM E-398)
- Flammability: Equal or better than products with Flame Spread Index 15 (ASTM E-162) UL 790 rating on Class A Roof Deck Factory Mutual Class 1 over existing Class 1 BUR system
- Service Temperature: -30° to 180°F
- Coverage: 1.0 gallon per 100 sq. ft. yields 10 mils dry. 2.0 gallon per 100 sq. ft. yields 20 mils dry.
- Recommended Coverage: Two coats (20mils) dry thickness
- Minimum Application Temperature: 45°F DO NOT ALLOW PRODUCT TO FREEZE
- Drying Time: 3 hours at 70°F, RH, to sustain foot traffic
- Packaging: 5 gallon plastic buckets 55 gallon drums
- Caution: Do not apply within two hours of darkness, rain, fog, or freezing temperatures. DURACOOL 1 must be completely dry before exposing to water or foot traffic. Keep DURACOOL 1 containers covered when not in use. Dispose of containers in accordance to state and local environmental regulations. Keep away from children. If ingested, do not induce vomiting. Call a physician immediately.
MATERIAL SAFETY DATA SHEET (MSDS)
SECTION I : PRODUCT IDENTIFICATION
MANUFACTURER’S NAME: DURACOOL, INC.
ADDRESS: 2635-C Northgate Avenue
Cumming, GA 30041
TELEPHONE #: (800) 232-9606
PRODUCT NAME: DURACOOL I
HAZARD RATINGS: HEALTH 1 0 = Least
1 = Slight
FLAMMABILITY 1 2 = Moderate
3 = High
SECTION II : HAZARDOUS MATERIAL IDENTIFICATION
HAZARDOUS COMPONENT OSHA ACGIH TLV OTHER %
_________________________ PEL TLV STEL _ _____
Ethanol, 2-(2-Methoxyethoxy) 50 ppm 50 ppm <5
Ethylene Glycol 50 ppm 50 ppm <5
SECTION III : PHYSICAL & CHEMICAL CHARACTERISTICS
Boiling Point : NA Vapor Pressure (mm Hg) : 15
Vapor Density (Air = 1) : 1.1 Solubility in water : Dispersible
Evaporation Rate (Butyl Acetate = 1 ) : <1
SECTION IV : FIRE & EXPLOSION DATA
Flash Point : None Unusual Fire and Explosion Hazards : None
Extinguishing Media : NA Flammable Limits : LEL : NA ; UEL : NA
Special Fire Fighting Procedure : None
SECTION V : REACTIVITY DATA
Stability : Stable
Incompatibility : Do not mix with other chemicals.
Hazardous Decomposition or By-Products : Carbon Dioxide ; Carbon Monoxide
Hazardous Polymerization : Will not occur
SECTION VI : HEALTH HAZARD DATA
Route(s) of Entry:
Inhalation Not irritating
Skin Possibly irritating
Ingestion Possibly irritating to digestive tract
Eyes Possibly irritating to eyes
Health Hazards (Acute and Chronic) None known
Carcinogenicity:
NTP Ingredients not listed
IARC Monographs Ingredients not listed
OSHA Regulations Ingredients not listed
Signs and Symptoms of Exposure:
Skin and Eyes Possible irritation to eyes
Inhalation Possible irritation to eyes
Ingestion Possible irritation
Medical Conditions Generally Aggravated by Exposure None
EMERGENCY & FIRST AID PROCEDURES:
SKIN CONTACT Rinse skin with clean water. Apply skin creams if irritation results.
EYE CONTACT Immediately flush eyes with clean water for 15 minutes. If irritation persists, GET MEDICAL/PHICIANS HELP.
INHALATION Remove to fresh air.
INGESTION Immediately drink large quantities of water. GET MEDICAL/PHYSICIANS HELP IMMEDIATLEY.
________________________________________________________________________________________________________________________________________________
SECTION VII : PECAUTIONS FOR SAFE HANDLING & USE
SMALL SPILLS: Dilute with plenty of water and flush in sanitary sewer.
WASTE DISPOSAL METHOD: Approved land fill, complying with all state, federal and local regulations.
PRECAUTIONS TO BE TAKEN IN HANDLING AND STORAGE: Do not allow product to freeze.
Keep containers closed when not in use. Keep product away from reach of children.
________________________________________________________________________________________________________________________________________________
SECTION VIII : CONTROL MEASURES
RESPIRATOR PROTECTION: Not Required
VENTILATION: Mechanical vent recommended for enclosed areas
PROTECTIVE GLOVES: Rubber or neoprene
EYE PROTECTION: Chemical goggles with side shields
OTHER PROTECTIVE CLOTHING OR EQUIPMENT: Not required
WORK/HYGIENIC PRACTICES: Use good housekeeping practices
SECTION IX : ADDITIONAL INFORMATION
ENVIRONMENTAL INFORMATION
WASTE DISPOSAL METHODS: Dispose waste in an authorized waste disposal facility in accordance with local, state and federal regulations.
WARNING: Empty container retains product residue and vapors. Observe all precautions even after container is empty. Washing container will not make it safe for food or cosmetic storage. Keep even empty containers tightly closed and away from the reach of children.
| 
